EPIX PIXCI EL1DB Dual Base Camera Link Frame Grabber In One PCI Express X1 Expansion Slot
Offering Wholesale, OEM, USA / International, GSA Government / Educational, Reseller / Retail, & Quantity Prices and Specifications / Datasheets, Installation Guides, and Operational Manuals.
Price Documents
→ PCI Express x1 Bus
→ 250 MB/sec Burst Data Transfers
→ 204 MB/sec Sustained Data Transfer
→ Line Scan or Area Scan
→ Camera Frame Rate Sequence Capture
→ Triggered Image Sequence Capture
→ 64-Bit Memory Addressing
→ Camera Integration & Async Reset Control
→ Integration From Microseconds to Minutes
→ Images Stored in Motherboard Memory or RAID Array
→ Windows & Linux, 32 & 64–bit Compatible
→ RoHS Compliant Boards Available
→ 250 MB/sec burst data transfer rate
→ Up to 204 MB/sec sustained data transfer from cameras to x1 PCI Express bus
→ Two Camera Control Dialogs - independent or shared exposure, bit depth, gain, frame rate, etc.
→ Cameras in free-run mode for maximum frame rate sequence capture
→ Cameras in control mode for triggered image capture
The EPIX Camera Link for PCI Express PIXCI-EL1DB frame grabber provides two interfaces for any two Base camera link cameras. The PIXCI EL1DB is handled by EPIX' software as if two PIXCI EL1 boards are installed. The EL1DB will accept two trigger signals one for each camera; or allows a single trigger to control capture from both cameras.
A strobe output signal is generated for each trigger. The PIXCI EL1DB frame grabber supports two cameras with a combined sustained bandwidth up to 204 MB/second. Compatible with the PCI Express x1 bus, the PIXCI EL1DB frame grabber interfaces to more than 100 of the newest, most advanced, highest bandwidth machine vision cameras available.
The PIXCI EL1DB is a plug-n-play frame grabber requiring no hardware setup or adjustment. Load the software, install the board, connect the cameras, and begin to capture images.
The XCAP imaging program supports up to 4 PIXCIEL1DB frame grabbers allowing use of eight Base configuration Camera Link cameras in the same computer. The XCAP-Std program allows simultaneous use of the PIXCI EL1DB with other EPIX® frame grabbers supporting different camera models, either Camera Link compatible or not. XCAP-Std also offers video-to-disk capture, subject to the performance of the host computer's RAID array.
Programmer's libraries and image processing subroutines are available from EPIX for solving the most difficult particle tracking, machine vision measurement, inspection, image sequence analysis, and flow analysis tasks. Third party software is also available.
Similar Models:
PIXCI EB1: Low Cost & Profile, PoCL Base Camera Link PCI Express Frame Grabber.
PIXCI EB1P: Low Cost & Profile frame grabber with Power over Camera Link (PoCL).
PIXCI EL1: Low Cost PCI Express x1 Frame Grabber for Camera Link Cameras.
PIXCI E4: PCI Express x4 Frame Grabber For High Bandwidth Camera Link Cameras.
PIXCI E4DB: Dual Base Camera Link Frame Grabber For PCI Express.
PIXCI E8: PCI Express x8 Frame Grabber For High Bandwidth Camera Link Cameras.
