→ Analog composite video input/output compatible. (Y/C is also supported.)
→ Full frame memory to prevent picture field inversion during processing.
→ 10-bit digital decode / encode to ensure stable signals without bit dropout.

The FOR-A FA 125 is a low cost Time Base Corrector / Frame Synchronizer. The FA125 corrects by up to one full frame the time base error/ phase shift problems that can occur during recording/playback of composite signals when using heterodyne process VTRs.

4	2:2 component internal signal processing.
Video Format	NTSC
Video Input	Analog composite = 1.0 Vp-p, 75Ω BNC x 1; Y/C Y = 1.0 Vp-p; C = 0.286 Vp-p; 75Ω 4-pin S-connector x 1
Genlock Input	BB = 0.429 Vp-p; 75Ω BNC x 1, loop-through (Terminate with 75Ω terminator, if unused.)
Video Output	Analog composite = 1.0 Vp-p, 75Ω BNC x 2; Y = 1.0 Vp-p; C = 0.286 Vp-p; 75Ω 4-pin S-connector x 1
Signal Processing	4:2:2 component
Correction Range	2 fields (field inversion prevented)
Sampling Frequency	Y = 13.5 MHz; C = 6.75 MHz
Quantization	10-bit
Frequency Response	100 kHz to 4.2 MHz = ±0.5 dB, 4.2 MHz to 5.0 MHz = -1.0 dB to 0 dB, roll off above 5.0 MHz
S/N Ratio	56 dB (no quantization noise)
DG/DP	2% / 2°
K-Factor (2T Pulse)	Less than 1%
H/V Tilt	Less than 1%
Residual Jitter	Y = ±15 ns; C = ±2°
Process Control	Video Level = -3 dB to 3 dB; Chroma Level = -3 dB to 3 dB; Setup Level = -15 IRE to 15 IRE; Chroma Phase = -30° to 30°
Genlock Phase Control	H Phase = -2 ?s to 2 ?s / SC Phase = -180° to 180°
Temperature	10°C to 40°C
Humidity	30% to 90% (no condensation)
Power	100 V AC to 240 V AC ±10%, 50/60 Hz
Consumption	29 VA (19 W) at 100 V AC, 37 VA (20 W) at 220 V AC
Dimensions	212 (W) x 44 (H) x 350 (D) mm
Weight	2.5 kg
Accessories	Operation manual, AC cord

Currently this model doesn't have any new resources

Currently this model doesn't have any similar models

Currently this model or manufacturer doesn't have any promotions

Currently this model or manufacturer doesn't have any new announcements