Hitachi KP-FB30SCL 0.33 Megapixel Black & White Mini Camera Link Industrial Camera

→ Imaging device: 1/3-inch interline CCD
→ Total pixels: 692(H) x 504(V)
→ Effective pixels: 659(H) x 494(V)
→ Pixel size: 7.4(H) x 7.4(V)μm(square lattice)
→ Drive frequency: 24.5454MHz
→ Scanning system: Progressive
→ Scanning frequency: Horizontal: 31.468kHz; Vertical: 59.94Hz; Vertical two pixel addition mode; Horizontal: 31.468kHz; Vertical: 119.65Hz
→ Sync system: Internal
→ Frame rate: 16.7ms/frames; 8.35ms/frames (Vertical two pixel addition mode)
→ Sensitivity: 400lx, F4, 3200 K (without IR cut filter)
→ Min. illumination: 7.4Lx, F1.4, MAX GAIN (without IR cut filter)
→ Signal to noise ratio: 50dB or more
→ Video output: Digital output: Camera Link standard; Data: Base configuration 10bit x 2channel; Clk = 24.5454MHz 10bit x 2channel
→ Power supply: 12 VDC ± 10%
→ Current consumption: 2.4 W
→ Electronic shutter speed: 1/60 to 1/100000 second (variable setting)
→ Frame on demand: One trigger, Fixed shutter (variable setting)
→ Partial scan: Selectable start position and width of picture grabbing in 1H step.
→ Offset: 16 to 128 setps level/10bit; 29 steps variable; Factory setting: 16 step level
→ Gamma compensation: Ɣ= 1
→ Gain setting: 0 to 12dB (301steps variable)
→ Lens mount: C mount
→ Resolution: Horizontal: 500TV lines; Vertical: 490TV lines
→ Ambient, operating: 0 to 40°C ( 32 to ; 104 F), less than 90 % RH
→ Ambient, storage: -10 to 50°C( 14 to 122 F), less than 70 % RH (Without Dew condensation)
→ Note: If operated continuously, be sure to use at less than 40℃(104 F) for long term stable performance.
→ Vibration endurance: 98 m/s² (Acceleration: constant);(10 to 200Hz,sweep:10 min,XYZ,30 min)
→ Shock endurance: 686 m/s² (Drop test, once each top, bottom, left and right)
→ External dimensions HEAD: 12.5 (W) x 12 (H) x 47.5 (D) mm; CCU: 29 (W) x 29 (H) x 38 (D) mm (not including protrusions)
→ Cable length: 3m
→ Mass: Approx. 60g