Search
By: JAI
http://www.avsupply.com/images/logos/jai-logo.jpg
CCD & CMOS Cameras
Contact us for lowest price (800) 284-2288, (858) 565-1101, sales@avsupply.com, or fax (858) 300-4193
1/2" Monochrome Progressive Scan 1.4 MP Camera

The CM-140GE is a monochrome progressive scan camera with 1.4 million pixels resolution and GigE Vision interface.  The camera utilizes the Sony ICX267 CCD and outputs 31 full frames/second in continuous (free-run) mode and up to 30 frames/second in external trigger modes. Higher frame rates can be achieved by using the Partial Scan or Vertical binning modes.  The unique sequencer function makes it possible to change the CM 140GE camera's exposure time, gain and ROI on the fly.  The CM140GE is also offered with a factory-installed Right Angle Adapter. The adapter enables the camera to "look" at a 90 degree angle and is designed for a range of inspection tasks where physical access on production lines is limited.

→ 1/2" monochrome progressive scan camera
→ Member of C3 Compact series, covering VGA to UXGA resolution
→ 1392 (h) x 1040 (v) 4.65 micro m square pixels
→ 31 frames/second with full resolution in continuous operation
→ 30 frames/second with external trigger and full resolution
→ Increased frame rate with vertical binning (CM-140 GE) and partial scan
→ Exposure time from 31 micro s to 2 sec. using Pulse Width trigger mode
→ Programmable exposure from 61.2 micro s to 32.2 ms
→ Sequencer trigger mode for on-the-fly change of gain, exposure and ROI
→ LVAL-synchronous/-asynchronous operation (auto-detect)
→ Auto iris lens video output allows a wider range of light
→ GigE Vision interface with 10 or 8-bit output
→ Partial scan
→ Unique sequencer function
→ Programmable GPIO with opto-isolated inputs and outputs
→ Comprehensive software tools and SDK for Windows XP/Vista

Sensor 1/2" progressive scan
Pixel Clock 65 MHz
Frame rate full frame 31.08 frames/second (1052 lines per frame)
Active area 6.4 (h) x 4.8 (v) mm
Cell size 4.65 x 4.65 pixels
Active pixels 1392 x 1040
Read-out modes, Full 1392 (h) x 1040 (v) 31.08 fps
Read-out modes, 1/2 partial scan 1392 (h) x 520(v) 46.57 fps
Read-out modes, 1/4 partial scan 1392 (h) x 260 (v) 61.92 fps
Read-out modes, 1/8 partial scan 1392 (h) x 130 (v) 73.97 fps
Read-out modes, 2/3 partial scan 1392 (h) x 694 (v) 39.97 fps
Read-out modes, Vertical binning 1392 (h) x 520 (v) 48.86 fps**NOTE: CM-140 GE only
Read-out modes, Region-of-interest (ROI) User definable. Memory read-out
Sensitivity (CM-140 GE) 0.3 Lux (On sensor, max. gain, shutter off, 50% video)
S/N ratio >50dB (0dB gain)
Video output GigE Vision, 8-bit or 10-bit
Auto-iris lens video output 0.7 Vp-p, enabled by internal switch
Gain Manual, -3 to 24 dB
Synchronization External hardware trigger via GPIO; Software trigger via GigE Vision
GPIO Module, Input/output switch Configurable 14-in/9-out switch (LUT)
GPIO Module, Clock generator (one) 12-bit counter based on 25MHz clock or Pixel Clock
GPIO Module, Pulse generators (four) 20-bit counters programmable for length, start point, stop point, repeat
Hardware trigger modes Continuous, Pre-Select, Pulse Width, Sequence (Gain, Shutter, ROI) Reset-continous trigger, Delay Readout
Electronic shutter, Pre-set shutter 1/31 to 1/10,000 in 10 steps
Electronic shutter, Programmable exposure 2L (61.2 micro s) to 1052L (32.2ms) in 1L steps
Electronic shutter, Exposure Time (Abs) micro sec - user definable. Same range as PE
Electronic shutter, Pulse Width 31 micro s to 2 sec.
Control interface Register based. GigE Vision/GenICam compliant
Functions controlled via GigE Vision interface Shutter, Gain, Black level, Trigger mode, Readout mode, GPIO setup, ROI (GenICam mandatory functions)
GigE Vision streaming control Packet size (1428 to 4040 bytes), Delayed (frame) Readout, Inter-packet delay
Indicators on rear panel Power / Hardware trigger, GigE link, GigE activity
Operating Temperature -5°C to 45°C
Humidity (operation) 20 - 90% non-condensing
Storage temp./humidity -25°C to 60°C / 20 to 90%
Vibration 10G (20Hz to 200 Hz XYZ)
Shock 70G
Regulations CE (EN 61000-6-2, EN-61000-6-3), FCC part 15 class B, RoHS/WEEE
Power 12V DC /-10%. 3.5W
Lens mount C-mount
Dimensions (H x W x L) 29 x 44 x 75 mm
Weight 125 g

 



facebook.png twitter.png googleplus.png linkedin.png youtube.png pinterest.png
Prices and specifications subject to change without notice.