| Sensor |
Sony ICX-285 2/3" progressive scan |
| Pixel Clock |
58 MHz |
| Frame rate full frame |
30 frames/second |
| Active area |
8.98 (h) x 6.7 (v) mm 2/3" diagonal |
| Cell size |
6.45 x 6.45 pixels |
| Active pixels |
1392 x 1040 |
| Color |
Raw Bayer output, host-based interpolation |
| Read-out modes, Full |
1392 (h) x 1040 (v) 30.12 fps |
| Read-out modes, 2/3 partial scan |
1392 (h) x 694 (v) 41.05 fps |
| Read-out modes, 1/2 partial scan |
1392 (h) x 520 (v) 50.06 fps |
| Read-out modes, 1/4 partial scan |
1392 (h) x 260 (v) 74.57 fps |
| Read-out modes, 1/8 partial scan |
1392 (h) x 130 (v) 98.73 fps |
| Read-out modes, Draft |
1392 (h) x 260 (v) 101.17 fps |
| Read-out modes, Variable Partical scan |
Start line from 1 to 1025, height from 8 to 1032, vertical. |
| Read-out modes, Region-of-interest (ROI) |
User definable. Memory read-out |
| Sensitivity |
0.2 Lux (On sensor, max. gain, shutter off, 50% video) |
| S/N ratio |
>58dB (0dB gain) |
| Video output |
GigE Vision, 8-bit, 10-bit or 12-bit |
| Auto-iris lens video output |
0.7 Vp-p, enabled by internal switch |
| Gain |
Manual/Automatic -6 to 24 dB |
| Synchronization |
External hardware trigger via GPIO. Software trigger via GigE Vision |
| GPIO Module, Input/output switch |
Configurable 16-in/12-out switch (LUT) |
| GPIO Module, Clock generator (one) |
12-bit counter based on Pixel Clock |
| GPIO Module, Pulse generators (two) |
19-bit counters programmable for length, start point, stop point, repeat |
| Hardware trigger modes |
Continuous, Pre-Select, Pulse Width, Sequence (Gain, Shutter, ROI), Reset-continous trigger, Delay Readout |
| Electronic shutter, Pre-set shutter |
1/30 to 1/10,000 in 10 steps |
| Electronic shutter, Programmable exposure |
2L (1/16,000 sec.) to 1052L (1/30 sec.) in 63 micro s step. |
| Electronic shutter, Exposure Time (Abs) |
micro sec - user definable. Same range as PE |
| Electronic shutter, Pulse Width |
63 micro s to 2 sec. |
| Electronic shutter, Auto shutter |
64L to 1052L |
| Pre-processing funtions |
In camera Bayer white balance, look-up-table (LUT), In-camera blemish compensation. |
| Control interface |
Register based. GigE Vision/GenICam compliant |
| Functions controlled via GigE Vision interface |
Shutter, Gain, Black level, Trigger mode, Readout mode, GPIO setup, ROI (GenICam mandatory functions) |
| GigE Vision streaming control |
Packet size (1428 to 16384 bytes), Delayed (frame) Readout, Inter-packet delay |
| Indicators on rear panel |
Power / Hardware trigger, GigE link, GigE activity |
| Operating Temperature |
-5°C to 50°C |
| Humidity (operation) |
20 - 90% non-condensing |
| Storage temp./humidity |
-25°C to 60°C / 20 to 90% non-condensing |
| Vibration |
10G (20Hz to 200 Hz XYZ) |
| Shock |
70G |
| Regulations |
CE (EN 61000-6-2, EN-61000-6-3), FCC part 15 class B, RoHS/WEEE |
| Power |
12V DC /-10%. 5.1W |
| Lens mount |
C-mount |
| Dimensions (H x W x L) |
55 x 55 x 55 mm |
| Weight |
230 g |
