Indoor Surface Mount Wedge Housing

The smooth curves of the low-profile Moog ACE-20 makes it a very attractive surface mount unit. Made of high-impact polycarbonate; it offers sturdiness. Molded-in hinges allows for total access to the camera from below. Hence installation is a snap and servicing simple. Tamper-resistant fasteners are included to protect the camera equipment from vandals.

The ACE-20 Features an Easy to Replace Window Guard paint shield, which allows vandalized viewing window to be quickly and economically restored to clarity.

The ACE 20 camera bracket is fully adjustable, and allows the camera to be either top or bottom mounted.

Available configurations

ACE20 Indoor Surface Mount Wedge: An off-white polycarbonate ceiling wedge housing with clear viewing window

ACEM20C Indoor Steel Surface Mount: An off-white powder coat 14-gauge steel ceiling wedge housing with clear 3/16” polycarbonate window with Window Guard™ paint shield

ACE20T Indoor Surface Mount Wedge with tinted viewing window

ACEM20CTH Outdoor Steel Surface Mount- ACEM20C with heater/thermostat

→ Off-white, high-impact polycarbonate housing and window
→ Easy installation to any type of ceiling
→ Molded-in hinge allows easy access from below
→ Fully adjustable camera bracket for top or bottom mounting
→ Right-angle BNC connector included for longer length cameras
→ Tamper-resistant fasteners

ACE20 / ACE20T: The body of the ACE20 housing is constructed from high-impact off-white polycarbonate, and contains a clear polycarbonate viewing window. The base plate is polycarbonate, and contains three conduit knockouts on the bottom section for control and video cable. The housing cover has been attached to the base plate, and secured with two tamper-resistant fasteners.

ACEM20C / ACEM20CTH: The body of the housing is constructed of 14-gauge steel, off-white powder coat, and contain a clear 3/16” polycarbonate window. An easy-to-replace Window Guard™ paint shield allows clarity of viewing window to be quickly and economically restored in case of vandalism. The base plate is a 18-gauge steel, and contains three conduit knockouts on the bottom section and a 7/8” hole on the rear of the base plate for control and video cable. The housing cover is secured to the base plate with four stainless steel 8 x 32 security screws. An optional 24Vac heater / thermostat is available for protected outdoor applications and for defogging the window.

ACEM20CTH only

Power Source: 24Vac, 50/60 Hz

Heater: 24Vac, 25vA, 1.04 Amps