Power Over CameraLink B/W Cube Cameras

The Sentech STC-POCL500A is a full featured, cost effective, QSXGA, digital Power Over CameraLink® cube camera. This camera delivers a full 5M Pixels resolution at 16 fps. It has a 2/3” color CCD with RGB Primary Color Filter and also features partial scanning, triggering, and reset capabilities.

Resolution	QSXGA (5 MegaPixel)
Image Sensor	2/3" Interline CCD (ICX625AQ)
Signal Format	Progressive: Monochrome
Frame Rate	16fps
Total Picture Element	2456 (H) x 2058 (V)
Active Picture Element	2448 (H) x 2058 (V)
Chip Size (mm)	3.45 (H) x 3.45 (V) μm
Cell Size (um)	9.93 (H) x 8.70 (V) mm
Vertical Frequency	16.0Hz
Horizontal Frequency	31.2kHz
Pixel Frequency	64.0 MHz
Scanning Method	Full Scan / Partial Scan (1/2, 1/4, Variable), Binning w/ B/W
Sync System	Internal
Communication	RS232 via CameraLink connector
Trigger Shutter	Pulse Width Trigger (V Reset, Non Reset), Edge Preset Trigger (V Reset, Non Reset)
Shutter Speed	OFF, 1/8 to 1/209,000 sec. (Variable at every H and clock)
Minimum Illumination	0.32 Lux @ F1.2
Gain	Adjustable Fixed Gain (0 ~ 16.3dB)
S/N Ratio	8bit output: <= 4 Digit (Gain 0dB); 10bit output: <= 15 Digit (Gain 0dB); 12bit output: <= 60 Digit (Gain 0dB)
Gamma	1.0
Lens Mount	C mount
Video Output	Digital 8, 10 or 12 bit CameraLink® (Base configuration)
Optical Filter	No IR cut filter
Optical Center Accuracy	Position accuracy of H and V direction: /- 0.31mm, I2°
Shock	70G (3 directions, 3 times each)
Vibration	10G (20 to 200Hz)
Power	12Vdc ± 10%
Consumption	< 4.0W, 333mA
Operating Temperature	-5°C ~ 40°C (23°F ~ 104°F)
Storage Temperature	-30°C ~ 65°C (-22°F ~ 140°F)
Dimensions	35(W) x 35(H) x 40.7(D) mm (1.38” x 1.38” x 1.6”) (Not including lens mount or the connector)
Weight	80g (2.82 oz)