4-Channel Video Passive Transceiver

The NVT 4-Channel Video Passive Transceiver NV-413A 4-channel Video Transceivers is a passive (non-amplified) device that allows the transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire. Baseband (composite) signals of any type are supported.

“Up-the-coax” type signal may be sent over the same wire pair. Used as a receiver, the NV-413A is fully compatible with qualified cameras that are equipped with an NVT twisted-pair output.

The unparalleled interference rejection and low emissions of the Model NV-413A allow video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the use of a shared or existing cable plant. With built-in transient protection, damaging voltage spike problems are eliminated.

NV-413A features include:

→ Two NV-413As can be mounted to an NV-RM 8/10 Rackmount Panel
→ Four passive transceiver channels in one product
→ Full-motion CCTV video at distances up to 750ft (225m) when used with a passive NVT transceiver or hub
→ Up to 3,000ft (1km) with a NVT DigitalEQ™ hub or active receiver
→ Up to 1,500ft (460m) with a NVT StubEQ™ hub
→ Supports pluggable screw terminal or RJ45 connections
→ No power required
→ Exceptional interference rejection
→ Frequency Response DC to 10 MHz
→ Built-in transient protection
→ Supports “up-the-coax” type control signal up to 750ft (225m)
→ Compatible with qualified UTP cameras
→ Two NV-413As may be rack mounted using the NV-RM8/10 Rack Panel Kit
→ Limited lifetime warranty