JAI BB-500GE-OP22-5-1 5-Megapixel 2/3" Color Progressive Scan CCD Camera, GigE Vision Interface With Extended Temperature Operation

→ 2/3" color progressive scan CCD
→ GigE Vision interface with 12-, 10-, or 8-bit output
→ 2456 (h) x 2058 (v) active pixels
→ 3.45 μm square pixels
→ 15 frames/second with full resolution
→ 5-megapixel CCD camera certified for extended temperature operation: -40°C to +65°C (standard temperature range is -5°C to +45°C)
→ Multiple shutter modes including auto shutter
→ Pre-processing functions including LUT for gamma/knee settings and blemish compensation
→ Increased frame rate with partial scanning modes
→ 2X vertical binning available on monochrome model
→ Draft mode (1/8 decimated) color readout at 37.5 fps
→ Pre-set, programmable or auto-shutter control
→ Manual or automatic gain control (-3 to +12 dB)
→ Built-in Bayer white balance and one-push channel balancing
→ Programmable look-up table for dynamic range control
→ Analog video output for auto-iris lens control
→ Comprehensive SDK and control tool software provided
→ Sensor: 2/3" progressive scan interline transfer CCD (ICX625ALA & ICX625AQA)
→ Active area: 8.45mm x 7.07mm
→ Active pixels: 2456 (H) x 2058 (V)
→ Cell size: 3.45 μm x 3.45 μm
→ Frame rate - full frame: 15 fps
→ Readout modes, Full: 2456 (H) x 2058 (V) 15 fps
→ Readout modes, 2/3 partial scan: 2456 (H) x 1372 (V) 20 fps
→ Readout modes, 1/2 partial scan: 2456 (H) x 1028 (V) 24 fps
→ Readout modes, 1/4 partial scan: 2456 (H) x 514 (V) 34 fps
→ Readout modes, 1/8 partial scan: 2456 (H) x 258 (V) 43 fps
→ Readout modes, Draft mode: 2456 (H) x 257 (V) 37.54 fps (BB-500GE only)
→ Readout modes, Region of interest (ROI): User definable memory readout
→ Synchronization: Internal/external hardware trigger via GPIO, Software trigger via GigE Vision
→ Pixel clock: 60.00 MHz
→ S/N ratio: >50 dB. (0 dB gain, standard temp.)
→ Sensitivity, Color: 1.0 lux (on sensor, max gain, shutter off, 50% video)
→ Video output: GigE Vision selectable (8-bit/10-bit/12-bit)
→ Auto-iris lens video output: 0.7 Vp-p, enabled by internal switch
→ Color: (BB-500GE only) Raw Bayer output for host-based interpolation
→ GPIO Module, Input/output switch: Configurable 16-in / 12-out switch
→ GPIO Module, Clock generator (1): 12-bit counter based on pixel clock
→ GPIO Module, Pulse generators (2): 19-bit counter programmable for length, start point, stop point, reset
→ Electronic shutter, Pre-set shutter: 1/15 (off) to 1/10,000 sec in 10 steps
→ Electronic shutter, Programmable exposure: 2L (64 μs) to 2072L (66.44 ms) in 1L steps
→ Electronic shutter, Pulse-width: 64 μs to 2 sec.
→ Pre-processing functions: Programmable LUT (Gamma 1.0 std), Bayer white balance, L/R channel balancing, blemish compensation
→ Lens mount: C-mount
→ Power: 12V DC ± 10%. 493 mA / 5.9W (typical at 25°C)
→ Operating temperature: -40°C to +65°C (Some reduced performance may occur when operating outside the -5°C to +45°C range)
→ Storage temperature: -50°C to +70°C
→ Vibration: 10G rms (20Hz to 200Hz XYZ)
→ Shock: 70G, 11 ms half sine
→ Dimensions: (HxWxL) 55 mm x 55 mm x 55 mm
→ Weight: 226 g (without tripod mount)