JAI CV-M4+CL Digital Double Speed Monochrome Megapixel Progressive Scan Camera

→ Digital 2/3" monochrome progressive scan CCD camera
→ 1392 (h) x 1040 (v) 6.45 μm square pixels
→ 24 frames/sec.
→ Extended IR sensitivity
→ 10 bit video output as Camera Link
→ LVDS version with 8 bit video output
→ Full 1380 (h) x 1030 (v) frame readout in 1/24 second
→ Higher frame rates with partial scanning or binning
→ Partial scan to 1/8 and vertical binning
→ Edge pre-select (EPS) and pulse width control (PWC) trigger modes
→ Restart continuous trigger (RCT) mode
→ Camera Link interface
→ Analog video ouput for controlling auto-iris lenses
→ Shutter speeds from 1/24 to 1/10,000 second in 10 steps
→ Trigger and timing signals as LVDS or via Camera Link
→ Setup by switches or serial control (short ASCII commands)
→ Windows 98/NT/2000 setup software
→ Scanning system: Progressive 1060 lines 24 frames/sec.
→ Pixel clock: 40.49 MHz
→ Line frequency: 25.43 kHz (1592 pixel clock/line)
→ Frame rate for full frame with V binning: 24 frames/sec. (1060 lines/frame)
→ Frame rate with V binning: 44 frames/sec. (565 lines/frame)
→ CCD sensor: 2/3" progressive scan monochrome IT CCD
→ Sensing area: 8.9 (h) x 6.6 (v) mm
→ Cell size: 6.45 (h) x 6.45 (v) μm
→ Effective pixels: 1392 (h) x 1040 (v
→ Pixels in video output, Full: 1380 (h) x 1030 (v) 24 frames/sec.
→ Pixels in video output, V binning: 1380 (h) x 515 (v) 44 frames/sec.
→ Pixels in video output, 1/2 partial: 1380 (h) x 512 (v) 44 frames/sec.
→ Pixels in video output, 1/4 partial: 1380 (h) x 256 (v) 70 frames/sec.
→ Pixels in video output, 1/8 partial: 1380 (h) x 128 (v) 102 frames/sec
→ Spectral sensitivity: 380 - 1000 nm
→ Sensitivity on sensor: 0.1 Lux (Max. gain, 50% video)
→ S/N ratio: >55 dB
→ Video A/D conversion: 10 bit
→ Video output digital: 8 bit LVDS (EIA 644), 10 bit in Camera Link
→ Iris video: 0.7 Vpp, 75 Ω
→ Gamma: 1.0
→ Gain: Manual
→ Gain range: -3 to + 12 dB
→ Synchronization: Int. X-tal. Ext. random trigger
→ Sync. output: Composite 4 Vpp from 75 Ω
→ Trigger input TTL: 4 V±2 V
→ EEN output: 4 Vpp from 75 Ω
→ Pixel clock output: LVDS or Camera Link
→ LEN/FEN output: LVDS or Camera Link
→ Trigger input LVDS: LVDS or Camera Link
→ Multiple exposure: LVDS or Camera Link
→ Trigger modes: Continuous, Edge pre-select, Pulse width control, Restart continuous trigger
→ Trigger in (Edge pre-select): >2 H
→ Shutter speed (fixed): 1/24 through 1/10,000 second
→ Pulse width control: 2 H to 3 frames. (80 μsec. to 72 msec.)
→ Frame-delay readout: Fixed shutter speeds. Delay ≤3 frames
→ Restart continuous trigger: Capture begins 133 lines after trigger input
→ Smearless readout: Edge pre-select, PWC and frame-delay
→ Multiple exposure Interval: ≤6 fixed exposures in frame-delay readout. Fixed shutter time + 1H (80 μsec.)
→ Camera setup by switches on rear: Shutter, Trigger, Scanning, Smearless, RS 232C control
→ Functions controlled by RS 232C: Shutter, Trigger, Scanning, Readout, Trigger input, Select/polarity, LEN/FEN/EEN polarity, Video level, Set-up level and Gain
→ Operating temperature: -5°C to +45°C
→ Humidity: 20 - 80% non-condensing
→ Storage temp./humidity: -25°C to 60°C/ 20% - 90%
→ Power: 12V DC ± 10%. 4.5 W
→ Lens mount: C-mount
→ Dimensions: 40 x 50 x 90 mm (HxWxD)
→ Weight: 250g