JAI CV-M7+CL 2/3" Bayer Mosaic Color Progressive Scan Camera

→ Digital 2/3" color progressive scan CCD camera
→ RGB primary color mosaic filter (Bayer) for host based RGB decoding
→ 1392 (h) x 1040 (v) 6.45 μm square pixels
→ Extended sensitivity compared with CV-M7
→ Host based color interpolation
→ 8 bit video output as LVDS (EIA 644) using 10 bit internal processing
→ Camera Link version with 10 bit video output
→ Full 1380 (h) x 1030 (v) frame readout in 1/24 second
→ Partial scan to 1/2, 1/4 and 1/8 for higher frame rate
→ Edge pre-select and pulse width external trigger modes
→ Frame-delay and smearless readout modes
→ Multiple exposure with up to 6 exposures within a single frame
→ Shutter speeds from 1/24 to 1/10,000 second in 10 steps
→ Trigger and timing signals as LVDS or via Camera Link
→ Setup by switches or serial control (short ASCII commands)
→ Windows 98/NT/2000 setup software
→ Scanning system: Progressive 1060 lines 24 frames/sec.
→ Pixel clock: 40.49 MHz
→ Line frequency: 25.43 kHz (1592 pixel clock/line)
→ Frame rate for full frame: 24 frames/sec. (1060 lines/frame)
→ CCD sensor: 2/3" progressive scan IT CCD with RGB primary color mosaic filter (Bayer)
→ Sensing area: 8.9 (h) x 6.6 (v) mm
→ Cell size: 6.45 (h) x 6.45 (v) mm
→ Effective pixels: 1392 (h) x 1040 (v)
→ Pixels in video output, Full: 1380 (h) x 1030 (v) 24 frames /sec.
→ Pixels in video output, 1/2 partial: 1380 (h) x 512 (v) 44 frames/sec.
→ Pixels in video output, 1/4 partial: 1380 (h) x 256 (v) 70 frames/sec.
→ Pixels in video output, 1/8 partial: 1380 (h) x 128 (v) 102 frames/sec
→ Sensitivity on sensor: 0.1 Lux (Max. gain, 50% video)
→ S/N ratio: >57 dB
→ Video A/D conversion: 10 bit
→ Video output digital (RGB in Bayer mosaic sequence for external RGB decoding): 8 bit LVDS (EIA 644); 10 bit in Camera Link
→ Video out (analogue for test): 0.7 Vpp, 75 Ω
→ Gamma: 1.0
→ Gain: Manual
→ Gain range: -3 to +12 dB
→ Synchronization: Int. X-tal. Ext. random trigger
→ Sync. output: Composite 4 Vpp from 75 Ω
→ Trigger input TTL: 4 V ± 2 V
→ EEN output: 4 Vpp from 75 Ω
→ Pixel clock output: LVDS or Camera Link
→ LEN/FEN output: LVDS or Camera Link
→ Trigger input LVDS: LVDS or Camera Link
→ Multiple exposure: LVDS or Camera Link
→ Trigger modes: Continuous, Edge pre-select, Pulse width control
→ Trigger in (Edge pre-select): >2 H
→ Shutter speed (fixed): 1/24 through 1/10,000 second
→ Pulse width control: 2 H to 3 frames. (80 μsec. to 72 msec.)
→ Frame-delay readout: Fixed shutter speeds. Delay = 3 frames
→ Smearless readout: Edge pre-select, PWC and frame-delay
→ Multiple exposure interval: =6 fixed exposures in frame-delay readout. Fixed shutter time + 1H (80 μsec.)
→ Camera setup by switches on rear: Shutter, Trigger, Scanning, Smearless, RS 232C control
→ Functions controlled by RS 232C: Shutter, Trigger, Scanning, Readout, Trigger input, Select/polarity, LEN/FEN/EEN polarity, Set-up level and Gain
→ Operating temperature: -5°C to +45°C
→ Humidity: 20 - 80% non-condensing
→ Storage temp./humidity: -25°C to 60°C/ 20% - 90%
→ Power: 12V DC ± 10%. 3.3 W
→ Lens mount: C-mount
→ Dimensions: 40 x 50 x 90 mm (HxWxD)
→ Weight: 250g