JAI EOC-B141GE High Sensitivity 2/3" Color Progressive Scan CCD Camera

→ High sensitivity 2/3" color progressive scan CCD
→ 1.4-megapixel CCD camera certified for extended temperature operation: -40°C to +65°C (standard temperature range is -5°C to +45°)
→ 6.45 μm square pixels with high sensitivity and NIR response
→ 1392 (h) x 1040 (v) @ 30 fps
→ Low noise, S/N ratio > 58 dB
→ Increased frame rate with partial scanning modes
→ 2X vertical binning available on monochrome model
→ Draft mode (1/4 decimated) color readout at 101.17 fps
→ GigE Vision interface with 12-, 10-, or 8-bit output
→ Pre-set, programmable or auto-shutter control
→ Manual or automatic gain control (-6 to +24 dB)
→ Built-in Bayer white balance and blemish compensation
→ Programmable look-up table for dynamic range control
→ Automatic Level Control (ALC) for integrated control of gain, shutter, and lens iris
→ Adjustable back focus
→ Multiple shutter modes including auto shutter
→ 30 fps continuous operation with full resolution
→ Pre-processing functions including LUT for gamma/knee settings and blemish compensation
→ GigE Vision interface
→ Comprehensive SDK and control tool software provided
→ Sensor: 2/3" progressive scan interline transfer CCD (ICX285 series)
→ Active area: 8.98mm x 6.7mm
→ Active pixels: 1392 (H) x 1040 (V)
→ Cell size: 6.45 μm x 6.45 μm
→ Frame rate - full frame: 30 fps
→ Readout modes, Full: 1392 (H) x 1040 (V) 30.12 fps
→ Readout modes, 2/3 partial scan: 1392 (H) x 694 (V) 41.05 fps
→ Readout modes, 1/2 partial scan: 1392 (H) x 520 (V) 50.06 fps
→ Readout modes, 1/4 partial scan: 1392 (H) x 260 (V) 74.57 fps
→ Readout modes, 1/8 partial scan: 1392 (H) x 130 (V) 98.73 fps
→ Readout modes, Draft mode: 1392 (H) x 260 (V) 101.17 fps (EOC-B141GE only)
→ Readout modes, Variable partial scan: Start line from 1 to 1025, height from 8 to 1032
→ Readout modes, Region of interest (ROI): User definable memory readout
→ Synchronization: Internal/external hardware trigger via GPIO Software trigger via GigE Vision
→ Pixel clock: 58.00 MHz
→ S/N ratio: >58 dB. (0 dB gain, standard temp)
→ Sensitivity, Mono: 0.03 lux (on sensor, max gain, shutter off, 50% video)
→ Sensitivity, Color: 0.2 lux (on sensor, max gain, shutter off, 50% video)
→ Video output: GigE Vision selectable (8-bit/10-bit/12-bit)
→ Auto-iris lens video output: 0.7 Vp-p, 75O
→ Color: (EOC-B141GE only) Raw Bayer output for host-based interpolation
→ GPIO Module. Input/output switch: Configurable 16-in / 12-out switch
→ GPIO Module. Clock generator (1): 12-bit counter based on pixel clock
→ GPIO Module. Pulse generators (2): 19-bit counter programmable for length, start point, stop point, reset
→ Electronic shutter, Pre-set shutter: 1/30 (off) to 1/10,000 sec in 10 steps
→ Programmable exposure 2L (63 μs) to 1052L (33.19 ms) in 1L steps
→ Electronic shutter, Pulse-width: 63 μs to 2 sec.
→ Pre-processing functions: Programmable LUT, Bayer white balance, blemish compensation
→ Lens mount: C-mount
→ Power: 12V DC ± 10%. 425 mA / 5.1W (typical at 25°C)
→ Operating temperature: -40°C to +65°C (Some reduced performance may occur when operating outside the -5°C to +45°C range)
→ Storage temperature: -50°C to +70°C
→ Vibration: 10G rms (20Hz to 200Hz XYZ)
→ Shock: 70G, 11 ms half sine
→ Dimensions: (HxWxL) 55 mm x 55 mm x 55 mm
→ Weight: 230 g (without tripod mount)