NVT NV-216A-PV Video Transceiver
Offering Wholesale, OEM, USA / International, GSA Government / Educational, Reseller / Retail, & Quantity Prices and Specifications / Datasheets, Installation Guides, and Operational Manuals.
Price Documents
→ Video Attenuation: 0.5 dB typ
→ Video Common-mode / Differential-mode rejection: 50 KHz to 10 MHz 60 dB typ
→ Video Impedance Coax, male BNC: 75 ohms
→ Video Impedance UTP, RJ45 data connector: 100 ohm
→ Network Wiring: One unshielded twisted pair 22-24 AWG (0,5-0,64mm)
→ Wire Category type: 2 or better
→ Wire Impedance: 100 ± 20 ohms
→ Wire DC loop resistance: 52 ohms per 1,000ft (18 ohms per 100m)
→ Wire Differential capacitance: 19 pF/ft max (62 pF/m max)
→ Temperature: -22 to 167 °F (-30 to 75°C)
→ Humidity (non-condensing): 0 to 95%
→ Transient immunity: per ANSI / IEEE 587 C62.4
→ Body Length: 1.6in (40,6mm)
→ Body Depth: 0.88in (22mm)
→ Body Height (not including BNC): 0.81in (20,5mm)
→ Product Weight: 1.0oz (30g)
→ Packaged Weight: 2.0oz (57g)
→ Power-Video (PV) signals are routed via UTP and RJ45
→ Use with NVT's PVD TM Power Supply Hubs and Cable Integrators, or with a second NV-216A-PV
→ Up to 750ft (225m) with a NVT Passive Hub or Transceiver
→ Up to1,500ft (460m) with a NVT StubEQ TM Hub
→ Up to 3,000ft (1km) with a NVT DigitalEQ TM Hub or active receiver, (see Power Distance Chart)
→ Frequency response DC to 10MHz (see Resolution Distance Chart)
→ Supports "up-the-coax" type control signal up to 750ft (225m)
→ Exceptional interference rejection
→ Built-in transient protection
→ Limited lifetime warranty
The NVT Video Transceiver NV 216A PV with Power is a passive (non-amplified) device that allows the transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire. Baseband (composite) signals of any type are supported.
The NVT Model NV216APV video transceiver allows transmission of CCTV video and low voltage power over UTP cable. The NV-216A-PV incorporates the transceiver engine of NVTs popular NV-214A-M video transceiver with the added value of camera power connections. Power and Video are routed via UTP and RJ45 connections. Used at the camera, the passive NV-216A-PV has a compact body, a male BNC for direct connection to the camera, and is compatible with NVT's PVD™ product line. Connect the RJ45 to 4-pair cable to be routed to the NVT cable integrator and on to an active or
passive receiver hub in the MDF/Control Room.
