Panasonic WV-CW244S Vandal-Proof Color Camera, Surface Mount

→ The surface mounted vandal resistant digital signal processing (DSP) mini dome color CCD cameras shall be a Panasonic Model WV-CW244S or equivalent. The WV-CW244S camera shall incorporate a 1/3" interline transfer CCD, 380,000 [768(H) x 494(V)] pixels effective, with a microlens on each pixel, and high sensitivity of 1.0 lux at f/1.4 (clear dome).The camera shall also achieve a sensitivity of 2.4 lux at f/1.4 (smoked dome).
→ The camera shall display outstanding 480 lines of horizontal resolution and a S/N ratio of 50dB with AGC off.
→ The camera's imager and lens assembly shall rotate on a three-axis hinge capable of Pan 320, Tilt 150 and Azimuth 320 adjustments for optimal camera positioning.
→ The camera shall be able to be semi-flush mounted on a wall or ceiling using a standard double-gang electrical box. The WV-CW244S camera shall feature a rugged weatherproof exterior housing meeting IP66 rating.
→ The WV-CW244S vandal resistant camera shall feature a local monitor output jack for on-site picture and positioning adjustments.
→ The camera shall feature intelligent digital back light compensation, digital wide dynamic range circuit and digital noise reduction for surveillance purposes under severe conditions. For better picture quality, the camera shall feature digital 2H enhancer, digital aperture correction, knee circuit and digital white detective ATW.
→ The WV-CW244S camera shall incorporate a 1/3", automatic iris, and 2X variable focal lens with a focal length of 3.8-8mm (2.1 X). The lens shall be suitable for use in areas where there is a varying light source. The lens shall have a maximum aperture ratio of 1:1.4 (wide), 1:1.8 (telephoto). The unit shall have an angular field-of-view of 35 degrees telephoto and 73 degrees wide (horizontal), and 26 degrees telephoto and 53 degrees wide (vertical).
→ The video and synchronization signal shall be transmitted up to 3000' over coaxial cable (Belden 9259 or equivalent), when used with the Panasonic model WJ-FS616C/WV-PB6164 multiplexer with control kit, matrix system model WJ-SX550C, matrix system WJ-SX850, single camera controller, model WV-CU161 and multiple camera controller Model WJ-MP204C, when used with Model WV-CU360 controllers. Equivalent coaxial cable used shall feature a DC resistance rating of less than 15 ohm/1000', solid copper center conductor and 95% braided, pure copper shield. VD2 shall provide roll free picture switching regardless of power supply phase.
→ The power source for the WV-CW244S shall be 24VAC, 60Hz. All units must be UL listed.