Toshiba-Teli CS8570D Double speed full frame monochrome camera; Internal/External Automatic switch-over sync, 1/2 type; 60fps

→ Image Sensor: All Pixel's Data Read-out Interline CCD
→ Total Pixels: 692(H) x 504(V)
→ Active Pixel: 659(H) x 494(V)
→ Video Output Pixels: 648(H) x 492(V) (Under non-interlace)
→ Scan Area: 6.4(H) x 4.8(V)mm (Equivalent to 1/2 type CCD size)
→ Unit Cell Size: 9.9(H)µm x 9.9(V)µm (Square-grid array)
→ TV System: Special format (Non-conforming to EIA)
→ Scan Lines: 525 lines
→ Interlace: 1/60s Non-interlace mode; 1/120s 2:1 Interlace mode; Switching via rear-panel DIP SW
→ Sync System: Internal/External automatic switch-over
→ Aspect Ratio: 4:3
→ Video Output: VS 1.0V(p-p) / 75Ω, DC coupled, 1 line (AC as [Option])
→ Resolution: 485 TV lines(H); 485 lines (350 TV lines)(V)
→ S/N: Standard: 52dB(p-p)/rms
→ Illumination: Standard 400 lx (F5.6); Minimum 4 lx (F1.4) (GAIN MAX, Approx. 50% video output)
→ Gain: FIX (Fixed) gain - Factory-shipped preset Level; MANU (Manual) gain - Setting through GAIN VR; FIX / MANU switching via rear-panel DIP SW
→ Gamma Correction: Gamma = 1 (Fixed)
→ White-Clip Level: Approx. 840mV(p-p) (Excluding Sync)
→ Power Source: 12VDC ±10%; Ripple voltage: 50mV (p-p) or less
→ Power Consumption: Approx. 1.5W
→ Internal Base Clock Frequency: 24.545MHz (1CLK) ±200ppm
→ Internal H Sync Frequency: 31.468kHz (1H = 780CLK)
→ Internal V Sync Frequency: 59.94Hz (Under non-interlace); 119.88Hz (Under 2:1 interlace)
→ External Sync Input Signal: HD/VD
→ Input Level: High impedance - 2 - 5V (p-p); 75Ω impedance - 2 - 5V (p-p)
→ Interlace: 1/60s non-interlace; 1/120s 2:1 interlace
→ Polarity: Negative
→ Pulse Width: HD - 3.2 ±1µs (LOW); VD - 125µs - 400µs (LOW)
→ Repeating Frequency: f_H = 31.468kHz ±1%; f_V = f_H/262.5 or f_H/525
→ Phase Difference: HD/VD: 0 ±5.0µs, l/f_H/2 ±5.0µs
→ Shutter Trigger Input Level: LOW level - 0 - 0.5V(p-p); HIGH level - 4 - 5V(p-p)
→ Shutter Trigger Input Impedance: High impedance - 10kΩ
→ Shutter Trigger Capture: Timing - Rising edge detection (Positive) / Falling edge detection (Negative)
→ Shutter Trigger Pulse Width: Min. 2µs; Max. 1/8s
→ Sync Signal Readout: WEN readout timing signal
→ Sync Signal Polarity: Rising edge - Positive under 1V mode
→ Electronic Shutter: Normal shutter - Shutter-speed setting via rear-panel SW (Initial OFF); 8 steps switchable(OFF, 1/200s, 1/500s, 1/l000s, 1/2000s, 1/4000s,1/8000s, 1/20000s)
→ External Dimension: 29 x 29 x 39.5(D)mm (Not including protrusion)
→ Weight: Approx. 41g
→ Lens Mount: C-Mount
→ Performance Guaranteed: Temperature 0 - 40°C; Humidity 30 - 90% (Non-condensing)
→ Operation Guaranteed: Temperature -5 - 50°C; Humidity 10 - 90% (Non-condensing)
→ Storage: Temperature -20 - 60°C; Humidity 10 - 90% (Non-condensing)
→ Electro-Magnetic Interference (EMI): Conforms to EN61000-6-4
→ Electro-Magnetic Suscpeptibility (EMS): EN61000-6-2 conformity
→ Double-Speed Scan: Twice the speed of conventional cameras
→ All Pixel Data Readout: Reads out image-data in approximately 1/60 sec even under Random Trigger Shutter (RTS) mode
→ Square-Grid Pattern CCD: Square grid pattern facilitates accurate image calculations
→ External Sync: Auto switched when HD signal detected
→ Random Trigger Shutter Function: Exposure synchronized with external trigger signals
→ Restart / Reset: Captures images at an arbitrary timing cued by external VD signal
→ Multiple Shutter: User-defined ex-trigger signal input / Outputs accumulated images at a set timing
→ Partial-Scan: Faster operation by capturing either 1/2 or 1/4 screen center
→ Ultra-Compact & Light-Weight Camera Head: Integrates with existing equipment while providing excellent shock and vibration resistance