37 fps, 0.8MP, B/W GigE camera, w/o IR cut filter, w/ POE

• User Programmable AOI

• Power Over Ethernet

• 0.8 Megapixel Resolution with 37 fps

Imager

1/3” interline XGA monochrome progressive CCD: ICX204AL

Total Picture Element

1077 (H) x 788 (V)

Active Picture Element

XGA: 1024 (H) x 768 (V)

Chip Size

5.5 (H) x 4.92 (V) mm

Cell Size

4.65 (H) x 4.65 (V) um

Scanning System

Progressive

Vertical Frequency

36.42113 Hz at full resolution; 0.44238 to 150.21358 Hz changeable via the communication; Maximum frame rate is dependent on the AOI setting; Maximum frame rate of the camera (150.21358 Hz) is 104 vertical resolution AOI setting.

Horizontal Frequency

28.9907 Hz

Pixel Frequency

36.818175 MHz

Noise Level

-

- @ 8Bit Output

<= 3 Digit (Gain 0 dB)

- @ 10Bit Output

<= 12 Digit (Gain 0 dB)

- @ 12Bit Output

<= 48 Digit (gain 0 dB)

Minimum Scene Illumination

0.95 Lux at F1.2, 36.42113 Hz

Sync System

Internal

Video Output

Digital 8 ,10 ,12 bit Raw Data

Interface

PoE: IEEE802.3af CLASS3 (1000BASE-T)

Protocol

GigE Vision 1.2 and GeniCam 2.0 compliant

Exposure Time

Preset continuous mode: 10 seconds to 16,777,216 seconds; Preset trigger mode: 10 seconds to 16,777,216 seconds; Pulse width mode: 10 seconds to Unlimited.

ALC

Electronic iris and AGC (ON/OFF)

Gain

0 to 20.4 dB

Gamma

Gamma 1.0 (Factory default) or downloadable gamma table

AOI (Area of Interest) Function

Programmable AOI setting via the communication

Smear Reduction

Selectable ON/OFF via the communication

Color Interpolation

N/A

White Balance

N/A

Trigger Mode

Edge preset trigger, pulse width trigger (unlimited exposure time)

Communication

UART communication through Ethernet Port

I/Os

One opt isolated input and two open collector outputs

Power

-

- Input Voltage

+10.8 to +26.4Vdc through power/IO connector or Power Over Ethernet; (Auto detection with power/IO connector prioritized)

- Consumption

12V: 2.4W / 2.3W, PoE: 2.6W / 2.5W

Dimensions

35 (W) x 35 (H) x 57.3 (D) mm excluding connectors

Optical Filter

No filter

Optical Center Accuracy

Positional accuracy in H and V directions: +/- 0.3 mm; Rotational accuracy of H and V: +/- 1.5 deg.

Material

Aluminum (AC)

Lens Mount

C Mount

Connectors

RJ45 connector; Power/IO connector: HR10A-10R-6PB (Hirose) or equivalent

Camera Mount Screws

Two ¼” Tripod screw holes (one each on top and bottom plate); Twelve M4 screw holes (four each on top, bottom, and two each on both side plates)

Weight

Approx. 130

Operating Temperature

- Minimum

Environmental Temperature: -5 deg. C

- Maximum

Camera housing temperature (top plate) shall not exceed 65 deg. C (This corresponds to an environmental temperature of approximately 40 deg. C)

Storage Temperature

Environmental Temperature: -30 to 65 deg. C

Vibration

20Hz to 200Hz to 20Hz (5min/cycle), acceleration 10G, 3 directions 30 min. each

Shock

Acceleration 38G, half amplitude 6ms, 3 directions, 3 times each

Standard Compliancy

EMS: EN61000-6-2, EMI: EN55011

RoHS

RoHS compliant