(discontinued) NVT NV-208-AM Single Channel Video Passive Transceiver

We have very few of these in our stock.

This item is DISCONTINUED.  For alternate solution see NV-215J-M.

The NVT Single Channel Video Passive Transceiver NV-208A-M Video Transceiver is a passive (non-amplified) device that allows the transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire. Baseband (composite) signals of any type are supported.

An improvement over NVT's popular NV-213A video transceiver, the passive NV-208A-M features a Screwless UTP terminal block and Male BNC allowing connection directly to the camera or DVR. It is capable of delivering a fully equalized signal to the DVR when used with any Active NVT Receiver, yet is compatible with all of NVT's passive products for applications under 750ft (225m). The NV-208A-M Video Transceiver also incorporates improved transient protection that eliminates the need for a ground screw.

The unparalleled interference rejection and low emissions of the NV-208A-M allow video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the use of a shared or existing cable plant.

NV-208A-M features include:

→ Full-motion CCTV video at distances up to 750ft (225m) when used with any passive NVT transceiver or hub
→ Up to 3,000 feet (1,000m) with a DigitalEQ TM Hub or active receiver
→ Up to 1,500 feet (460m) shall be supported by any NVT StubEQ TM Hub
→ Frequency response DC to 10MHz (see Resolution Distance Chart)
→ Male BNC allows connection directly to the camera or DVR
→ Reliable Screwless UTP terminal connection
→ No power required
→ Exceptional interference rejection
→ Built-in transient protection
→ Supports “up-the-coax” type control signal up to 750ft (225m)
→ Limited lifetime warranty