Call Now: 1-800-284-2288 |
30 fps, 2.0MP, B/W GigE camera, w/o IR cut filter, w/ POE |
|
|
The STC-SB202POEHS is part of Sentech's Brand New Power over Ethernet High Speed GigE camera series. It features a 1/1.8" monochrome UXGA sensor, 30fps and communication over a 6 pin Hirose or Ethernet connector. The STC-SB202POEHS boasts a compact 35(w) x 35(H) x 55.9 (D) mm size, a user-programmable Area of Interest (AOI) and a Gamma Table that can be imported. This camera meets all industry standards for GigE Vision® and GenICam™, and is compatible with all standard industry drivers. The GigE PoEHS series is available now at an extremely low cost.
STC-SB202POEHS features include:
|
|
|
Imager |
1/1.8” interline UXGA monochrome progressive CCD: ICX4274AL |
Total Picture Element |
1688 (H) x 1246 (V) |
Active Picture Element |
UXGA: 1624 (H) x 1236 (V) |
Chip Size |
8.5 (H) x 6.8 (V) mm |
Cell Size |
4.4 (H) x 4.4 (V) um |
Scanning System |
Progressive |
Vertical Frequency |
30.29207 Hz at full resolution; 0.57871 to 121.16830Hz changeable via the communication; Maximum frame rate is dependent on the AOI setting; Maximum frame rate of the camera (121.16830 Hz) is 104 vertical resolution AOI setting. |
Horizontal Frequency |
37.9257 Hz |
Pixel Frequency |
72.81683 MHz |
Noise Level |
- |
- @ 8Bit Output |
<= 3 Digit (Gain 0 dB) |
- @ 10Bit Output |
<= 12 Digit (Gain 0 dB) |
- @ 12Bit Output |
<= 48 Digit (gain 0 dB) |
Minimum Scene Illumination |
0.16 Lux at F1.2, 15.31668 Hz |
Sync System |
Internal |
Video Output |
Digital 8 ,10 ,12 bit Raw Data |
Interface |
PoE: IEEE802.3af CLASS3 (1000BASE-T) |
Protocol |
GigE Vision 1.2 and GeniCam 2.0 compliant |
Exposure Time |
Preset continuous mode: 10 seconds to 16,777,216 seconds; Preset trigger mode: 10 seconds to 16,777,216 seconds; Pulse width mode: 10 seconds to Unlimited. |
ALC |
Electronic iris and AGC (ON / OFF) |
Gain |
0 to 20.4 dB |
Gamma |
Gamma 1.0 (Factory default) or downloadable gamma table |
AOI (Area of Interest) Function |
Programmable AOI setting via the communication |
Smear Reduction |
Selectable ON / OFF via the communication |
Color Interpolation |
N/A |
White Balance |
N/A |
Trigger Mode |
Edge preset trigger, pulse width trigger (unlimited exposure time) |
Communication |
UART communication through Ethernet Port |
I/Os |
One opt isolated input and two open collector outputs |
Power |
- |
- Input Voltage |
+10.8 to +26.4 Vdc through power/IO connector or Power Over Ethernet; (Auto detection with power/IO connector prioritized) |
- Consumption |
12V: 4.1W / 3.9W, PoE: 4.4W / 4.2W |
Dimensions |
35 (W) x 35 (H) x 57.3 (D) mm excluding connectors |
Optical Filter |
No filter |
Optical Center Accuracy |
Positional accuracy in H and V directions: +/- 0.3 mm; Rotational accuracy of H and V: +/- 1.5 deg. |
Material |
Aluminum (AC) |
Lens Mount |
C Mount |
Connectors |
RJ45 connector; Power/IO connector: HR10A-10R-6PB (Hirose) or equivalent |
Camera Mount Screws |
Two ¼” Tripod screw holes (one each on top and bottom plate); Twelve M4 screw holes (four each on top, bottom, and two each on both side plates) |
Weight |
Approx. 130 |
Operating Temperature |
|
- Minimum |
Environmental Temperature: -5 deg. C |
- Maximum |
Camera housing temperature (top plate) shall not exceed 65 deg. C (This corresponds to an environmental temperature of approximately 35 deg. C) |
Storage Temperature |
Environmental Temperature: -30 to 65 deg. C |
Vibration |
20 Hz to 200 Hz to 20 Hz (5min. /cycle), acceleration 10G, 3 directions 30 min. each |
Shock |
Acceleration 38G, half amplitude 6 ms, 3 directions, 3 times each |
Standard Compliancy |
EMS: EN61000-6-2, EMI: EN55011 |
RoHS |
RoHS compliant |
Call Now: 1-800-284-2288 |
|||||
Email Us: sales@avsupply |
|||||
|