EthernetConnect Extender with 1, 4, 8, or 16 ports with true PoE to 30 Watts, local or remote

The EC-3000C Series is ideally suited for applications where the existing coaxial cable needs to be leveraged for transmission of IP signals. For UTP applications, the EC-3000U Series is an effective Cat5/Cat5e/Cat6 UTP extender device beyond the 100 m (328 feet) limit of traditional Ethernet. In addition, for system configurations that have a single cable connected to the camera, the EC-3000C/U Series can become a true PoE device and source PoE to the powered device. This eliminates the need for midspans or PoE-enabled Ethernet switches to provide a fully 802.3at compatible application. Designed to be a cost-effective, advanced-use product, the EC-3000C/U Series provides maximum flexibility in these applications without any programming.

The EthernetConnect™ EC-3000C/U Series is used to extend Ethernet over copper (EoC). The EC-3000C Series extends up to 16 channels of 10/100 Mbps Ethernet with PoE+ power injection and pass-through PoE+ over coaxial cable. The EC-3000U Series extends up to 16 channels of 10/100 Mbps Ethernet with PoE+ power injection and pass-through PoE+ over twisted pair cable (Cat5/ Cat5e/6 UTP). With the ability to connect directly to a PoE+ switch or the ability to generate PoE+ power with a 48 V input to either the local or remote ends, these units provide the ultimate flexibility for extending a powered device (PD) over long distance copper.

A complete set includes both a local and a remote module. Remote modules are small unit size in either a one- or four-channel configuration. Local modules are also available in the small unit size in one- or four-channel configuration as well as available in a 1 RU rack size for larger channel counts. All application configurations should be verified at the time of ordering to facilitate ease of installation.

Available Models

MODELS EC-3000C SERIES (COAXIAL CABLE)

Local

EC-3001CLPOE-M EthernetConnect local single-port coaxial extender with true PoE to 30 W, EoC using coaxial cable, mini case, 12 VDC/48 VDC, 24 VAC

EC-3004CLPOE-W EthernetConnect local 4-port coaxial extender with true PoE to 30 W, EoC using coaxial cable, wall-mount

EC-3008CLPOE-R EthernetConnect local 8-port coaxial extender with true PoE to 30 W, EoC using coaxial cable, 1 RU rack-mount

EC-3016CLPOE-R EthernetConnect local 16-port coaxial extender with true PoE to 30 W, EoC using coaxial cable, 1 RU rack-mount

Remote

EC-3001CRPOE-M EthernetConnect remote single-port coaxial extender with true PoE to 30 W, EoC using coaxial cable, mini case, 12 VDC/48 VDC, 24 VAC

EC-3004CRPOE-W EthernetConnect remote 4-port coaxial extender with true PoE to 30 W, EoC using coaxial cable, wall-mount

EC-3000U SERIES (UTP CABLE)

Local

EC-3001ULPOE-M EthernetConnect local single-port UTP extender with true PoE to 30 W, EoC using Cat5/Cat5e/Cat6 UTP, mini case, 12 VDC/48 VDC, 24 VAC

EC-3004ULPOE-W EthernetConnect local 4-port UTP extender with true PoE to 30 W, EoC using Cat5/Cat5e/ Cat6 UTP, wall-mount

EC-3008ULPOE-R EthernetConnect local 8-port UTP extender with true PoE to 30 W, EoC using Cat5/Cat5e/ Cat6 UTP, 1 RU rack-mount

EC-3016ULPOE-R EthernetConnect local 16-port UTP extender with true PoE to 30 W, EoC using Cat5/Cat5e/ Cat6 UTP, 1 RU rack-mount

Remote

EC-3001URPOE-M EthernetConnect remote single-port UTP extender with true PoE to 30 W, EoC using Cat5/Cat5e/Cat6 UTP, mini case, 12 VDC/48 VDC, 24 VAC

EC-3004URPOE-W EthernetConnect remote 4-port UTP extender with true PoE to 30 W, E

• Transmits Individual Ethernet Data Channels with Power over Ethernet Plus (PoE+) Power Injection and Pass-Through PoE+ over Standard Cat5/Cat5e/Cat6 UTP Cable or Coaxial Cable
• Extends Ethernet up to 914 m (3,000 ft) at 10 Mbps or 610 m (2,000 ft) at 100 Mbps over Cat5/Cat5e/Cat6 UTP Cable
• Extends Ethernet up to 1,524 m (5,000 ft) at 10 Mbps or 549 m (1,800 ft) at 100 Mbps over Coaxial Cable
• Extended Temperature Operation from –40° to 75°C (–40° to 167°F)
• Extended Pass-Through PoE Meets the IEEE802.3at Standard for Power over Ethernet
• Full 10/100 Mbps Bandwidth
• Supports Multicast, Unicast, and Jumbo Frame
• Symmetric Bandwidth Provides Consistent Upload and Download with Virtually Zero Packet Loss over the Total Usable Distance
• Type Tested to RFC-2544 TCP/IP Network Bandwidth Packet Transmission Standards
• User-Selectable Data Rate for Maximum Bandwidth and Transmission Distance Utilization
• Complies with all Major IEEE Standards and RFC Network Protocols for UDP, TCP/IP, HTTP/HTTPs
• Tested and Certified by an Independent Laboratory for Full Compliance with the Environmental Requirements (Ambient Operating Temperature, Mechanical Shock, Vibration, Humidity with Condensation, High-Line/Low-Line Voltage Conditions, and Transient Voltage Protection) of NEMA TS-1/TS-2 and the Caltrans Specification for Traffic Signal Control Equipment
• LED Status Indicators Confirm Operating Status
• Available in Small Unit Size, Interchangeable Stand Alone, or 1 RU Rack Mounted-Models
• Designed and Manufactured in the USA

ELECTRICAL

Operating Voltage

Pass-Through Mode

• 1 CH N/A; Optional input voltage 12 to 32 VDC or 18 to 32 VAC
• 4 CH 12 VDC, 5W; 9 VDC† when in a USRACK or EURACK
• 8 CH 12 VDC, 10 W
• 16 CH 12 VDC, 20 W

Power Injection Mode

• 1 CH 48 to 56 VDC, 30 W
• 4 CH 48 to 56 VDC, 120 W
• 8 CH 48 to 56 VDC, 240 W
• 16 CH 48 to 56 VDC, 480 W

Current Protection Automatic resettable solid-state current limiters

MTBF >100,000 hours

LED Indicators Operating power; PoE power; Ethernet link and activity; extended link and activity

DATA

Data Interface 10/100Base-T Ethernet

Data Rate DIP switch selectable 10/100 Mbps; full data rate/full-duplex up to the maximum rated distance

RFC 2544 TCP/IP packet transmission

Standards

• PoE+ IEEE802.3af/at
• RFC 768 UDP, 2068 HTTP, 793 TCP, 791 IP, 1783 TFTP, 894 IP over Ethernet

*Distance figures are based on a 50 V PSE PoE power source, and external power supplies for the extenders. Distance figures are obtained using in-house testing mirroring installations. Factors such as coaxial and copper cable quality, the number of connectors and splices in the cable run, the use of PoE, and environmental conditions encountered within the installation might affect the actual transmission distance and should be taken into consideration.

MECHANICAL

Connectors Ethernet RJ-45

Extended Interface Coaxial Female BNC UTP RJ-45

Operating Power Powered by PoE or two-pin screw terminal

GENERAL

Dimensions

• 1 CH 8.4 x 6.4 x 2.8 cm (3.3" D x 2.5" W x 1.1" H)
• 4 CH 15.5 D x 13.5 x 2.8 cm (6.1" x 5.3" W x 1.1" H)
• 8 CH 15.5 x 48.26 x 4.45 cm (6.1" D x 19" W x 1.75" H)
• 16 CH 15.5 x 48.26 x 4.45 cm (6.1" D x 19" W x 1.75" H)

Operating Temperature –40° to 75°C (–40° to 167°F)

Storage Temperature –40° to 80°C (–40° to 176°F)

Relative Humidity 0% to 95%, noncondensing

Shipping Weight

• 1 CH <0.5 kg (1 lb)
• 4 CH <0.9 kg (2 lb)
• 8 CH <2.3 kg (5 lb)
• 16 CH <2.3 kg (5 lb)

CERTIFICATIONS/RATINGS

CE, Class A

FCC, Part 15, Class A

UL/cUL Listed

C-Tick

Designed to meet NEMA TS-1/TS-2 and the Caltrans traffic signal control equipment environmental standards